Black Epoxy Adhesive For Batteries

If you are planning to wholesale best cheap and high quality black epoxy adhesive for batteries China, or hot sale black epoxy adhesive for batteries in China from professional black epoxy adhesive for batteries manufacturers and suppliers and factory, please feel free to contact SEPNA, and welcome to check products price with us.Black Epoxy Adhesive For Batteries SE2136B◆Detailed Product DescriptionSE2136B is a two-component solvent-free room temperature curing black poles epoxy potting adhesiveFeatures 1.Good toughness and moderate hardness.2.Excellent adhesion, anti-cracking resistance.3.Excellent electrical insulating properties,stability.4.Good waterproof, moisture resistance, low water absorption.5.Acid resistance.UsageFor sealing and protection of batteries and photovoltaic LED, lighting products, outdoor transformer with excellent adhesion.◆Data tableCharacteristics before hardeninSE2136BPartABAppearanceBlack liquidLight yellow liquidViscosity, mPa.s(25℃)2000-3000100-150Proportion , g/cm3(25℃)1.18±0.051.02±0.05Mixture/mass ratio,2:1Viscosity after mixing , mPa.s (25℃)540±100Operation time after mixing, mins (25℃)70±20Gel time (25℃)4-5hCuring time24h(25℃)/120min(80℃)Hardness, Shore D75±5Water absorption 24h，25℃，%<0.1 %Dielectric strength, KV/mm,(25℃)>20Dielectric Constant（1MHz）(25℃)3.53Dissipation factor (1MHz）(25℃)0.015Volume resistance DC500V, Ω·cm1.35×1015Temperature range ,  ℃-40～80Note:①All data above were tested under standardized condition.②All data listed in the chart were for the generalized item in the series; please refer to the related datasheet for special items.③Storage condition has a direct impact to the products’ shelf life, Please refer to the instruction for special items’ storing◆Operation1.Stirring A component evenly before using it .2.Weighed in a 2:1 ratio A, B two components, stir well stay with after vacuum deaeration to use within 70 minutes run out.3.Good potting devices ,if necessary, continue to pumping vacuum, help to increase the electrical performance of the device.4.Curing conditions: 25 ° C for 24hrs at room temperature .5.Note: adhesive start the reaction after adhesive preparation , accompanied by heat release. With the greater amount of glue, the greater the heat release, the shorter operating time, required in a shorter period of time you are finished using 6.The above tests are measured under 100 g with adhesive.◆Package and StoragePackage                                 Part A : Transparent, 10kg/bucket        Part B: Brown, 5kg/pot StorageSeal and Avoid light and lightTemperature≤25℃, humidity≤50%RHShelf life: Part A 12 months, Part B 12 months◆Safety Operation MaterialMSDS isn't included here. Please read TDS, MSDS and label carefully before operation.You can get MSDS from Sepuna or other distributors, or mail to service center [email protected], or call +86-400-882-1323.◆Product WarrantyAll product properties and application details based on information believe to be reliable and accurate. But you still need to test its property and safety before application. The advices we supply don't apply in any circumstances. Sepuna don't make assurance of any other applications outside the specification until Sepuna supply a special written guarantee. Sepuna is only responsible to replace or refund if this product is defective within the warranty period stated above. Sepuna makes it clear that will not be liable of any accidents.